AIR COMPRESSOR

Contact Us

  • A&S Aerodynamic Co., Ltd
  • Address: No. 469, Xinsheng Road, Gaoxin District, Chengdu, Sichuan, China
  • Tel: +86-28-65376575
  • Fax: +86-28-86129221
  • Email:
    aircompressor@electrical8.com
  • Contact Person:Laura Tse

Air Compressor Preventive Maintenance Checks

Checking Compressor Pump Oil Level - 
Unless your air compressor is an oil free compressor, do not operate without lubricant or with inadequate lubricant. Manufacturers and the company from whom you bought it from cannot be responsible for failure do to inadequate lubrication. 
  1. Ensure unit is off and disconnect from the power source
  2. Ensure compressor is on a flat and level surface
  3. Remove fill cap / plug
  4. Inspect the oil in the crankcase assembly and look for dirt or debris
  5. Oil should not exceed the halfway point of the sight glass
 
Changing Compressor Pump Oil- 
Remember, the compressor pump head and surrounding parts are HOT!
  1. Ensure unit is off and disconnect from the power source
  2. Ensure compressor is on a flat and level surface
  3. Remove fill cap / plug
  4. Place collection container underneath the oil drain cap.
  5. Remove the oil drain cap, and let the oil drain out.
  6. Replace the oil cap and be sure to tighten this nut securely. Teflon tape is generally a good idea to help create a tighter seal. Fill crankcase with appropriate oil, be sure it does not exceed the halfway point.
Checking the air filer element -  
For the more common reciprocating air compressors.
  1. Ensure unit is off and disconnect from the power source
  2. Allow compressor pump to cool off.
  3. Unscrew the filter top from the filter base by turning (generally) counter-clockwise.
  4. Separate the filter top cover from the base.
  5. Remove the element from the filter base
  6. Blow out dust and debris from the filter element.
  7. Replace element if needed.
  8. Reconnect filter top to the base and secure filter.
Checking the air filer element -  
For the more common reciprocating air compressors.
  1. Ensure unit is off and disconnect from the power source
  2. Allow compressor pump to cool off.
  3. Unscrew the filter top from the filter base by turning

Please Complete the short form below and a A&S sales representatives will contact you shortly. Note: Fields labeled with a * are required.
* Product:
* First Name:
* Last Name:
* Company:
  Phone:
   Fax:
*  Email:
*  Inquiry / Comments
*  Code
 
page run: 10.3 ms